BRAZE MATE Model 100
SEQUENCE OF OPERATION:
- Operator loads assembly into stainless steel fixture.
- Paste applied with automatic dispenser gun.
- Dual, zero-pressure, "touch" buttons depressed to actuate automatic
heating/cooling cycle.
- Joined assembly unloaded by operator; rates up to
60 per hour.
|
SPECIFICATIONS CONSTRUCTION: Structural aluminum frame with clear acrylic guarding on three sides. DIMENSIONS: 36"W x 48"D x 34" load height; operator can be seated. PASTE APPLICATOR: Two modes available, hand-held or stationary mounted. HEATING:
Rigid steel gas train includes air pressure switch, gas flow meter,
and manifold pressure gauges. Single-axis heat slide oscillates
throughout timed heat cycle to eliminate "hot spots"
at assembly joint area. Quick-change heat manifold adapts to different
part requirements. COOLING: Timed air and water sequence; water captured in stainless steel trough; optional water recirculating system available. FIXTURES: Stainless steel mounted on "unistrut"; quotations based on assembly prints and parts. CONTROL: PLC with Operator Interface Panel to change timers and counters. UTILITIES: 120 volts, single phase, 5 amp; natural gas or propane; 80 psi air, water and drain. |
Oscillating burners distribute heat evenly throughout
the joint area.
Hinged door provides easy access to utilities and heat controls.
FUSION INCORPORATED
4658 E. 355th St., Willoughby, OH 44094
Phone 1-800-626-9501 o (440) 946-3300
Fax (440) 942-9083 o e-mail: sales@fusion-inc.com
